
10623 Roselle Street, San Diego, CA 92121 y (858) 550-9559 y Fax (858) 550-7322 [email protected] y www.accesio.com
Manual WWP-IIRO-8 10Antenna Installation Screw the directional antenna onto the coaxial connector on the side of the enclosure until it is snug. Scr
Manual WWP-IIRO-8 11 Input and Relay Connections Route all input wiring through the same gland that you routed power. Route all output wiring throug
Manual WWP-IIRO-8 12 Chapter 3: Hardware Details Option Selections Filter Response Jumpers Jumpers are used to select input filtering on a channel
Manual WWP-IIRO-8 13 Chapter 4: Connector Pin Assignments ‘Isolated Input’ Terminal Block PCB Signal ‘Relay Output’ Terminal Block PCB Signal 1 GN
Manual WWP-IIRO-8 14 Chapter 5: Specifications General • Intelligence: Type 8051 microcontroller family provides capability of local control • Pro
Manual WWP-IIRO-8 15 Relay Outputs • Number: Eight • Contact Form: SPDT (form C) • Contact Type: Single Crossbar • Contact Material: Silver +
Manual WWP-IIRO-8 16 Customer Comments If you experience any problems with this manual or just want to give us some feedback, please email us at: ma
Manual WWP-IIRO-8 2 Notice The information in this document is provided for reference only. ACCES does not assume any liability aris
Manual WWP-IIRO-8 3 Warranty Prior to shipment, ACCES equipment is thoroughly inspected and tested to applicable specifications. However, should equ
Manual WWP-IIRO-8 4 Table of Contents Chapter 1: Introduction ...
Manual WWP-IIRO-8 5Chapter 1: Introduction Features • Wireless Digital Input / Relay Output Module Pair • Each input on one unit is mapped to con
Manual WWP-IIRO-8 6The units are packaged in NEMA4 enclosures for remote installation in harsh environments. These units act wirelessly, saving time a
Manual WWP-IIRO-8 7 Figure 1-2: Block Diagram Depicting Two-Way (Pair of Units) Signal Flow
Manual WWP-IIRO-8 8 Ordering Guide WWP-IIRO-8 Pair of WWM-IIRO-8's (8 Inputs / 8 Relays, x2) WWP-II-8/RO-8 One WWM-II-8 paired with one
Manual WWP-IIRO-8 9Chapter 2: Installation Prior to installing the pair into their final locations, it is recommended you bench test the units side b
Comentários a estes Manuais